CommLink Command Line Options
Options :: Setup :: Start Up :: Wait :: Command Line :: Return Codes

The Communications Link program supports several Command Line Options. Options entered on the command line over ride options in the INI file. The options are not case sensitive and can be in any order:

Example:

Start Commlink for Connection with 3 retries 30 seconds apart using INI file “C:\Some Dir\Setup.ini”

Example:

Start CommLink using the options specified in the setup.ini file

-I option can be used alone or with any of the other options. If the –I option is not specified the default file name used is “CommLink.Ini”. If “CommLink.ini” is found in the same folder as the executable it will be read to determine the setup. If “CommLink.ini” is not found the default values will be used. If the –R, –F, or –W option(s) are specified on the command line, values set in the INI file are ignored.

-R # Specifies the number of times to retry a failed connection. To retry the connection 3 times specify –R 3. If you use the –R option without the –F option the frequency of retries defaults to 30 seconds.

-F # indicates the frequency in seconds between retries. To wait 30 seconds between retries use –F 30. If you use the –F option without the –R option the retries defaults to 3.

-S Displays the setup screen and does not attempt a connection or wait for a session.

-W Loads the kernel and waits for a successful session.

-K If CommLink is already running this will end CommLink

Options :: Setup :: Start Up :: Wait :: Command Line :: Return Codes

RemoteWare® is a registered trademark of XcelleNet Inc. These products are not endorsed or supported by XcelleNet.